USAutomatic PATRIOT RSL Manuale Utente Scaricare il pdf

TROUBLESHOOTING PATRIOT

RSL SLIDE GATE OPERATOR

TROUBLESHOOTING SECTION

OUTLINE

1 My slide gate operator will not operate

2 Emergency release knob cannot be pulled

3 I can hear gate operator running but my gate is not moving:

4 Gate operates slowly when opening or closing, may stop before cycle is complete:

5 My gate will not automatically close:

6 Gate begins to open or close but stops and reverses after a couple of seconds.

7 Gate opening or closing stops and reverses direction and then stops and will not operate

8 Gate opens or closes correctly then immediately reverses direction:

9 Gate closes then opens back up in 10 seconds or more, auto close timer is on

10 Control board 15 amp fuse blows when open/close command is given.

11 Transmitter (Remote control) will not operate the gate.

12 Photo eye, safety loop or other safety accessory will not reverse the gate when closing.

13 Pressing the “RESET” button only, causes the gate to operate.

Terms and Definitions

Led - Light emitting diode, small red lights on control board.

Control board- Located inside the metal box just above the battery.

Receiver - Located inside the metal box in the upper right corner, coax cable connected to it.

Transmitter - Hand held push button, which is used to operate the gate, sends signal to receiver.

Harness - Wire bundle connected to the control board, limit switch plate and motor.

Connector - Control board has two types. Two white 8-pin connectors (X1 and X2) are used to connect

actuator to control board and one green 12-pin connector (J2) (located bottom center of control

board) to connect receiver and accessories to control board. Both are plug type and can be

disconnected (unplugged from control board) without disconnecting wires.

Dip Switches - Small switches, which are located on the control board in two places. The primary set DS1 is

located in the upper left corner and the secondary set DS2 are located in the lower right corner

of the control board with functions listed beside each. See manual (page 15, 16) for more

information. Open position is off or switch not closed.

Push Buttons - Three are located on the control board. “Open/Close command” used to operate the gate, “Led

Indicator” used to activate the leds and the “Reset” used to reset the control board after current

sensing twice before a limit is reached.

1 2 3 4 5 6 7

Sommario

Pagina 1 - RSL SLIDE GATE OPERATOR

TROUBLESHOOTING PATRIOT RSL SLIDE GATE OPERATOR 1 TROUBLESHOOTING SECTION OUTLINE 1 My slide gate operator will not operate 2 Emergency relea

Pagina 2

TROUBLESHOOTING PATRIOT RSL SLIDE GATE OPERATOR 2 Limit Switch Plate – Located on top of the operator, holds the two limit switches and also hold

Pagina 3

TROUBLESHOOTING PATRIOT RSL SLIDE GATE OPERATOR 3 3. I can hear gate operator running but my gate is not moving: STEP 1 The most likely cause

Pagina 4

TROUBLESHOOTING PATRIOT RSL SLIDE GATE OPERATOR 4 5. My gate will not automatically close: NOTE: If DS1 switch 1 is on and switch 2 is off the

Pagina 5

TROUBLESHOOTING PATRIOT RSL SLIDE GATE OPERATOR 5 7. Gate opening or closing stops and reverses direction and then stops and will not operate S

Pagina 6

TROUBLESHOOTING PATRIOT RSL SLIDE GATE OPERATOR 6 For example if the left led is on that is the open limit and the gate should be in the open posi

Pagina 7

TROUBLESHOOTING PATRIOT RSL SLIDE GATE OPERATOR 7 12. Photo-eye, safety loop or other safety accessory will not reverse the gate when closing or

Commenti su questo manuale

Nessun commento

USAutomatic PATRIOT RSL Manuale Utente

Navigare online o scaricare Manuale Utente per Strumenti per giardinaggio USAutomatic PATRIOT RSL. TROUBLESHOOTING PATRIOT RSL SLIDE GATE OPERATOR Manuale Utente

Sommario

Commenti su questo manuale

Prodotti e manuali riguardandi Strumenti per giardinaggio USAutomatic PATRIOT RSL